全 55570 件が検索されました。（9201 - 9220件を表示）
- マニュアル
...Operation Manual EUROPE OMRON EUROPE B.V. Sensor Business Unit Carl-Benz Str.4, D-71154 Nufringen Germany Phone: 49-7032-811-0 Fax: 49-7032-811-199 NORTH AMERICA OMRON ELECTRONICS LLC One Commerce Drive Schaumburg, IL 60173-5302 U....
- マニュアル
... gases may be present. 2. Do not use beyond rated supply voltage or under AC power supply. Explosion or burning may be caused. 3. Do not short the circuit. Explosion or burning may be caused. 4. Do not mix up DC pole'...
- マニュアル
... ON させる場合は、「NC」に設定します。 （ が点灯） UP/DOWN MODE UP/DOWN 測定値 白デジタルスマートチューニングボタン 【S.TUNE】ボタンチューニングを実行します。 しきい値の微調整 【UP/DOWN】ボタン緑デジタルのしきい値が変わります。 モード切替出力切替 【MODE】...
- マニュアル
.... Control output Terminal Arrangement 1 DC5V∼24V 2 ia 3 0V d -3.2 Omron Companies shall not be responsible for conformity with any standards, codes or regulations which apply to the combination of the Product in the Buyer’...
- マニュアル
... 2 m, attach a capacitor with a capacitance of approximately 10 µF to the wires as shown below. The distance between the terminal and the capacitor must be within 2 m. (Use a capacitor with a dielectric strength that is at least twice the Sensor'...
- マニュアル
....59N・m at maximum. Even for this type of installation, do not fail to use the tie bands. Mechanical durability : 10 to 55Hz , 1.5mm double amplitude in X, Y, and Z directions, respectively for 2 hours each Shock Mechanical durability : 500m/...
- マニュアル
....59N・m at maximum. Even for this type of installation, do not fail to use the tie bands. Mechanical durability : 10 to 55Hz , 1.5mm double amplitude in X, Y, and Z directions, respectively for 2 hours each Shock Mechanical durability : 500m/...
- マニュアル
...L Light-ON EE-SPZ401-A GND ＊ Voltage output (when the sensor is connected to a transistor circuit) Omron Companies shall not be responsible for conformity with any standards, codes or regulations which apply to the combination of the Product in the Buyer’...
- マニュアル
...OFF OUT2 (White) (Contorol output) GND (Blue) 2 3 4 5 to 24 VDC OMRON shall not be responsible for conformity with any standards, codes, or regulations that apply to the combination of the products in the customer'...
- マニュアル
...carefvllybe拍reuslngtheproduct ▲ 途 ■Wiring・一− Donottouchthetemlnalswhllepowerlsbelngsupplled Dolngsomayoccastonallyresultmmlnormjuryduetoelectrlcshock Useapowersupplythatcomplleswlththerelnforcedlnsulatlon △ speαhedlnIEC60664fortheEJlexternalpowersupplyorthepower supplyconnectedtotheEJIlfrlon-compllantpowersuppllesare used,electrlcshockmayoccaslonallyresultlnmmorInＬury −Dorlotallowplecesofmetal、wlrecllPPIngs,or加emeta‖lcshavmgs orf山ngsfromInstallatlontoentertheproduct,Dolngsomay occaslonallyresultlnelectrlcshock,flre,ormalfunctlon DonotusetheproductwheresublecttoflammableorexploslvegasOtherwlse,mlnorlnluryfromexploslonmayoccaslonallyoccur ⑤ Neverdlsassemble,modlfy,orrepalrtheρroductortouchanyofthe mtemalpa戊...
- マニュアル
...서사용하는 경우 전파간섭의 우려가 있습니다. SUITABILITY FOR USE Omron Companies shall not be responsible for conformity with any standards, codes or regulations which apply to the combination of the Product in the Buyer'...
- マニュアル
...safely and properly. Be sure you are using the most current version of the manual. Model/Manual name Cat No. CJ1W-NC□81/□82 Position Control Unit Operation Manual W487 NJ Series CPU Unit Built-in EtherCAT Port User'...
- マニュアル
...safely and properly. Be sure you are using the most current version of the manual. Model/Manual name Cat No. CJ1W-NC□81/□82 Position Control Unit Operation Manual W487 NJ Series CPU Unit Built-in EtherCAT Port User'...
- マニュアル
... Module. Remove the ROM Module pulling up both side of the ROM Module. ④ Place the new ROM Module in positipn. Connect the connector of the ROM Module tightly. Tighten up the screw surly. ⑤ Attach the battery cover. Please be careful of battery’...
- マニュアル
... securely. PRECAUTIONS FOR CORRECT USE Please observe the following precautions to prevent failure to operate, malfunction, or undesirable effect. Connecting and disconnecting the cables Be sure to turn off the power before connecting or disconnecting the cables. Handling the Camera The Camera'...
- マニュアル
...(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ■ FCC CAUTION Change or modifications not expressly approved by the party responsible for compliance could void the user’...
- マニュアル
...ト 取扱説明書 （日/英） Precautions for Safe Use F39-BTLP Lamp and Bluetooth® Communication Unit for F3SG Series EN Instruction Sheet Thank you for purchasing Bluetooth® Communication Unit for F3SG Safety Light Curtain. Read this document and user'...
- マニュアル
...ユニット 取扱説明書 （日/英語） Model F39-GIF-1 Interface Unit for F3SG-RR Safety Light Curtain EN Instruction Sheet Thank you for purchasing Interface Unit for F3SG-RR Safety Light Curtain. Read this document and user'...
- マニュアル
...state after terminating SD Manager 2 Check the noise level in the environment. Restore the factory default setting by Setting Recovery, and make settings again. PC Thank you for purchasing Interface Unit for F3SG Safety Light Curtain. Read this document and user'...
- マニュアル
...説明書 （日/英語） [Included parts and quantites] EN Instruction Sheet Thank you for purchasing this product. The product is Spatter Protection Cover dedicated for F3SG-RA Series Safety Light Curtain. Read this document and F3SG-R Series User’...